Origami 3d Star Instructions

2 Likes  |  Difficulty: High Intermediate

Designed by: GMKworld
A lovely 3D star made out of a pick colored paper. It could be hung for home / Christmas / Birthday decoration. It is simply cute

Step 1

Step 1a) Make or Get a Square shaped Paper, Ensure all four sides are equal i.e 4cm by 4cm depending on how big your preference is for sizes Step 1b) Make a Valley fold: fold one diagonal end Step 1c) Smoothen fold with thumb or a Ruler

Step 2

Step 2a) Repeat Valley fold on the other diagonal end Step 2b) Make a Mountain fold on the vertical sides and also repeat for the horizontal sides Step 2c) Smoothen fold with thumb or Ruler

Step 3

Step 3a) Open up the folds Step 3b) Flip over to the other side and fold in two diagonal sides Step 3c) Smoothen fold with thumb or Ruler

Step 4

Step 4a) Pick the leftmost diagonal edge and fold over to the straight center line Step 4b) Smoothen fold with thumb or Ruler Step 4c) Pick the rightmost diagonal edge and fold over to the straight center line to kiss the other identical fold in '4a' above

Step 5

Step 5a)Turnover to the other side Pick the leftmost diagonal edge and fold over to the straight center line Step 5b) Smoothen fold with thumb or Ruler Step 5c) Pick the rightmost diagonal edge and fold over to the straight center line to kiss the other identical fold in '5a' above

Step 6

Step 6a) Pick the crown/head of the formed kite-like shape Step 6b) Fold over, bending on the straight line of division between the lower triangle & the upper one Step 6c) Smoothen folds with thumb or a Ruler edge.

Step 7

Step 7a) Turn over to the other side and open up the fold Step 7b) Open the inner fold from the crown of the triangle Step 7c) Open the fold to its full length

Step 8

Step 8a) Make a new diamond shape by folding inwards along the defined lines Step 8b) Smoothen the fold with thumb or Ruler edge Step 8c) Turn over to the other side and repeat steps '7a' to '8b'

Step 9

Step 9) Turn over to the other side and repeat steps '7a' to '8b'

Step 10

Step 10a) Release the wings - the head looks like this Step 10b) Release the wings - the side looks like this Step 10c) Further spread the crown/head of the formed shape to bring out the square edges

  • 1
  • 2
  • 3
  • You are reading Origami 3d Star Instructions by GMKworld.